Danckaert sliding circular saw big 28" blade, works but spares/repair.
Danckaert 28" sliding circular saw bench. All these machines have been sat unused for a considerable time, and are very old. They are sold strictly on a spares or repair basis, not to be considered working fit for purpose. It is the purchasers responsibility to check what (if any!) health and safety requirements any of these machines do or do not meet, also to have any required electrical safety tests carried out prior to use. None are to be considered WORKING, or FIT FOR PURPOSE. Removed recently from a local sawmill. Ive run it up and it seems to operate fine Requires a 3 phase power supply 28" blade None of the adjusters are seized solid, but everything is a bit tight through sitting unused. This one was removed from a roller table fed setup. As pictured there are NO safety covers in place as all the moving parts were covered by the table. Also the saws own table is incomplete as it used to be attached to the roller table. The blade travels up and down the full length of the frame. Very large, very capable and powerful unit that could be re- installed into a good setup again. Due to the lack of safety covers though it could also be very dangerous indeed- it will have SOLD FOR SCRAP stated on the invoice due to this.
Please Note: The rates provided below are for guidance only and are in no way guaranteed rates of exchange.